Sensor scan
When scanning sensors, only the sensors themselves will be listed. Scanned sensors can be viewed from the sensor settings screen.
1
Tap A.
The sensor settings screen will open.
2
Tap B. The scan will begin.
3
Tap the “C” next to the sensor you want to capture data from to check the box. The indicator for the tapped sensor will blink.
4
Tap D.
Sensor registration will begin.
To scan for additional sensors, tap E. Scanning will begin. Proceed from step 3.
Deregister the sensor
*All settings made to the target device using this system will be reset, and the connection to the mesh network will be disconnected.
1
Tap F. The sensor will blink.
Confirm that it is the correct sensor.
2
Tap G.
The settings screen will open.
3
Tap H. A confirmation screen will open.
Tap I. The deregister is complete.
Restart the sensor
1
Tap F. The sensor will blink.
Confirm that it is the correct sensor.
2
Tap G.
The settings screen will open.
3
Tap J.
Restart complete.