Other equipment

Lighting fixtures with wireless communication capabilities that can be controlled by this system.
They have a built-in (or external) wireless module.
Please use lighting fixtures that are listed as “wireless dimming” in our catalog.　
Devices must be installed within a line-of-sight radius of 25m.

This device has a built-in no-voltage a-contact relay.
It can be connected to an AC100V remote control breaker. It
can also be connected as a contact control for DC30V control devices.
It is used when you want to turn on/off or schedule operation of non-wireless devices such as outdoor lighting.

This device can wirelessly control our PWM signal-controlled lighting fixtures.
Up to 50 PWM signal type lighting fixtures can be connected to one unit.

This device can wirelessly control our phase-controlled LED lighting fixtures.
Each unit can connect to a load of 4VA to 300VA.

This is a device for controlling our wired control type lighting fixtures.
Lighting fixtures connected to the wired repeater can be operated collectively with the same settings
(color temperature, pale color, DuV, dimming rate)
. Dimmable/Tunable/Synca type lighting fixtures cannot be connected together. Please refer to the instruction manual for details.

This is a Furyu with wireless communication function that can be controlled by this system.
Furyu can circulate air, can set 16 levels of air volume, and can be combined with scenes. Fade cannot be set.

This is a device that relays wireless communications between devices.
It is used when the communication distance between devices cannot be maintained within a line of sight of 25m. For details on installation, etc., please refer to the instruction manual for the repeater.

This repeater can be powered from an outlet and does not require any electrical work.